[usercalin]

Hi! did anyone install the top yoke nut from Gilles? If so, how did you manage not to scratch it?

The original scrambler nut got a mark even if it was wrapped in wire tape.
The shop used a hex key like this:

Do you think one like this

would be better?
Or maybe you have a recommendation for some tool manufacturer producing some low tolerance key?

 

[Keets]

An adjustable spanner with heat shrink over the jaws and a lot of patience?
Have you asked Gilles?

 

[Boxer Metal]

Adjustable Pin Wrench/Spanner

 

[Keets]

Adjustable Pin Wrench/Spanner

That looks better

 

[BlitzSchnell]

Adjustable Pin Wrench/Spanner View attachment 139594

You’re right Boxer, that’s the ticket ....

 

[IslandFalconer]

I have one installed. Wrap your socket internally with masking tape use a 6 point socket. Do not use an impact.

 

[usercalin]

I have one installed. Wrap your socket internally with masking tape use a 6 point socket. Do not use an impact.

This was my initial idea. i think i'll try it since i can use a torque wrench with it

 

[usercalin]

ok, i got a reply from gilles: