Just a couple of additional photos showing how I connected and the bungee cord mounting.:

 

Hi all, I noticed the lens on my headlight was cracked. I want to replace with a not to expensive LED light. About 50% of my time is spent riding at night. I was looking at the LedPerf LED light but not sure which Type model I Should get. Was thinking the Type 2.
If anyone has fitted one how did it work out.

Many thanks, Iain

 

Hello,

Im just wondering if anyone resolved the issue with the Can bus triggering on Hi beam. I can cure the dip and side lights with resistors but the Hi beam eludes me.
Also do any UK owners know if flashing the Halo orange when indicating along with the indicators would attract the attention of our esteemed law guardians?

 

I have had an LED Perf light installed for a couple of years with no problems. Recently, the low-beam went out. LED Perf sent me a new light (which was great). However, upon installation, I noticed the "resistor" that is in-line on the DRL wiring adapter has gotten very hot, and is brittle. Just touching it caused the end to come off and I'm sure it will not last. Has anyone else experienced this problem (and/or have a solution)?

 

Can't say that I have seen that before but if the resistor power dissipation is too low that would certainly be a likely outcome over time.
I bought a unit from a local cars spares shop and have made one myself. They have not been tested long term though.